TYPE C PORT

Product details of TP 4056 C Type USB Type C USB 5V 1A 18650 TP4056 Lithium Battery Charger Module Charging Board with Protection Dual Functions 1A Li-ion

• Dual function charger for 18650 lithium batteries.
• USB Type C input with 5V 1A charging capability.
• Blue color design, suitable for camera accessories category.
• Provides protection for the battery during charging.
• Compact module with TP4056 for efficient and safe charging.
Product Description:
Introducing the TP4056 C Type USB Lithium Battery Charger Module, designed for efficient charging of 18650 lithium batteries. This blue charger board features a USB Type C input and provides a 5V 1A output, ensuring reliable and safe charging. With dual functions and built-in protection, it is ideal for camera enthusiasts seeking a dependable battery charging solution.

This TP4056 1A Li-Ion Battery Charging Board Type C with Current Protection is a tiny module, perfect for charging single cell 3.7V 1 Ah or higher lithium-ion (Li-Ion) cells such as 16550s that don’t have their own protection circuit. Based on the TP4056 charger IC and DW01 battery protection IC this module will offer 1A charge current then cut off when finished.

Furthermore, when the battery voltage drops below 2.4V the protection IC will switch the load off to protect the cell from running at too low of a voltage – and also protects against over-voltage and reverse polarity connection (it will usually destroy itself instead of the battery) however please check you have it connected correctly the first time.

Using the module:
Connect Type C cable for power, or 5V DC to pads marked IN+ and IN- on the left-hand side of the module
Connect cell to charge to B+/B- pads on the right-hand side of the module.
A load (something for the battery to power) can be connected to the OUT+/OUT- pads on the right-hand side
Important! Disconnect load when charging
The red LED indicates charging in progress, the green LED indicates charging has finished.
Never charge your battery at a rate greater than 1C.
NOTE:
1. Ampere meter can only be connected to a 5v input end of the module.
2. It is better than the charging current is 37% of the battery capacity. If you charge the battery of 1000mAh, a current of 400mAh is enough.
3. The connection wire should not be too thick.
4. Make sure the connect point is good.
5. If the input voltage is too high, like 5.2v, the current will be less than 1000mA, it is normal. It is protection function, auto-subtract the charging current to avoid burn damage to the chip.
6. NO Reverse polarity.

MINI USB PORT

Features:

• This TP4056 specification charger board allows user to charge battery using either a Mini USB connector at 4.5V - 5.5V input voltage
• Input Interface: Mini USB port
• Charging method: linear charge.
• A full charge voltage: 4.2V.
• Charge Current: 1A (default), modify the onboard resistor to adjust the charging current
• Charging accuracy: 1.5%.
• Charging indicator: Blue LED charging, Red LED full.
• Output Reverse: lithium batteries can not reverse.
• Dimensions: 22 x 17mm.
• Color : Blue

Package Content :

• 1 X  5V Mini USB 1A TP4056 Lithium Battery Module

​ 

Write a review