NRF24L01 + 2.4GHZ Wireless Transceiver module for Arduino

NRF24L01 + 2.4GHZ Wireless Transceiver module for Arduino

Product Code: Transceiver Module
Availability: In Stock
Stock Ready: Kuala Lumpur

- +
   - OR -   

100% Quality Guarantee
Output power, frequency channels, and protocol setup are easily. 
Programmable through a SPI interface. Current consumption is very low, only 9.0mA at an output power of -6dBm and 12.3mA in RX mode. 
Built-in Power Down and Standby modes makes power saving easily realizable. 
Maximum operating speeds up to 2Mbps, GFSK modulation efficiency, Anti-interference ability, Particularly suitable for industrial control applications. 
125 Communications channels, Multi-point communication and frequency hopping to meet the communication needs. 
Built-in hardware CRC error detection, 
Multipoint communication address control. 
Low-power 1.9 ~ 3.6V, only 1uA on Power down mode. 
Built-in 2.4Ghz antenna. 
Available software to set the address, only received local Address when output data(Provide interrupt instruction), can be directly connected to a variety of microcontrollers, Software programming is very convenient. 
Support 6 Data channels of data reception. 
Standard DIP Pitch Interface for embedded applications. 

NRF24L01-02.jpg NRF24L01-03.jpg NRF24L01-04.jpg NRF24L01-05.jpg NRF24L01-06.jpg NRF24L01-07.jpg NRF24L01-08.jpg NRF24L01-09.jpg NRF24L01-10.jpg NRF24L01-11.jpg NRF24L01-12.jpg NRF24L01-13.jpg NRF24L01-14.jpg NRF24L01-15.jpg

Write a review

Your Name:

Your Review: Note: HTML is not translated!

Rating: Bad           Good

Enter the code in the box below: