HX711 Weighing Sensor Dual-Channel 24 Bit Precision Module Arduino

HX711 Weighing Sensor Dual-Channel 24 Bit Precision Module Arduino

Product Code: Weighing Sensor
Availability: In Stock
Stock Ready: Kuala Lumpur

- +
   - OR -   

Description :

  • This module uses 24 high precision A / D converter chip hx711
  • It is a specially designed for the high precision electronic scale design, with two analog input channel, the internal integration of 128 times the programmable gain amplifier.
  • The input circuit can be configured to a bridge type pressure bridge (such as pressure, weighing sensor mode), is of high precision, low cost is an ideal sampling front-end module.


  • Two selectable differential input channels 
  • On-chip active low noise PGA with selectable gain of 32, 64 and 128 
  • On-chip power supply regulator for load-mobile and ADC analog power supply 
  • On-chip oscillator for which no external component with optional external crystal 
  • On-chip power-on-reset 
  • Simple digital control and serial interface: pin-driven controls, no programming required 
  • Selectable 10SPS or 80SPS output data rate 
  • Simultaneous 50 and 60Hz supply rejection 
  • Power consumption including on-chip analog power supply regulator: normal operation <1.5mA, power down <1uA 
  • Operation of supply voltage range: 2.6 ~ 5.5 V 
  • Operation temperature: -40 ~ + 85 °

Specification :
Color: as a picture show
Size: 25mm x 15mm / 1.56 "x 0.79" (inch) (approximately)
This module uses 24 high-precision A / D converter chip hx711. 
HX711-02.jpg HX711-03.jpg HX711-04.jpg HX711-05.jpg HX711-06.jpg HX711-07.jpg HX711-08.jpg HX711-09.jpg HX711-10.jpg HX711-11.jpg HX711-12.jpg

Write a review

Your Name:

Your Review: Note: HTML is not translated!

Rating: Bad           Good

Enter the code in the box below: